ET
Junior Member
Posts: 65
|
ESC ??
Jun 21, 2006 18:36:42 GMT 12
Post by ET on Jun 21, 2006 18:36:42 GMT 12
I have just got a ESC for my car TL-01...near new (TEU-101bk) and my receiver is a (Futaba FP-R122JE) Every time i turn the car on the ESC just Beeps away and doesn't stop ...hehe... Crystals are fine.... I tried the MSC to see if my car still goes and all i got was my front wheels turning Left and right.... my Receiver wasn't turning over the motor....is my receiver stuffed?? Can someone please help me.... Cheers ET......
|
|
Stockyboy
Junior Member
Stockyboy Photos thanks to GTP
Posts: 67
|
ESC ??
Jun 21, 2006 19:11:55 GMT 12
Post by Stockyboy on Jun 21, 2006 19:11:55 GMT 12
Hey ET have you programmed the ESC?? Sorry could come round today had homework but will try have a geez tommorow. Easy and simple to programme. Make sure you have your engine disconnected. Throttle trim on neutral. Turn on ESC and Controller Push set button four about 1sec so the light flashes 3 times Pull triger to max throttle then press set. light does double flash. Push triger to max reverse and push set button. Light will then turn off and you are set to go!!
|
|
ET
Junior Member
Posts: 65
|
ESC ??
Jun 21, 2006 20:42:34 GMT 12
Post by ET on Jun 21, 2006 20:42:34 GMT 12
Nah still no go... as the red light just keeps flashing non stop More help please
|
|
ET
Junior Member
Posts: 65
|
ESC ??
Jun 22, 2006 14:21:02 GMT 12
Post by ET on Jun 22, 2006 14:21:02 GMT 12
I think it's my receiver, as it doesn't even work with the std MSC. So yea if there are any Futaba (FP-R122JE) for sale give me a pm Cheers ET
|
|
ET
Junior Member
Posts: 65
|
ESC ??
Jun 23, 2006 14:03:46 GMT 12
Post by ET on Jun 23, 2006 14:03:46 GMT 12
ok i got it going thanks for your fellas help...lol
|
|
|
ESC ??
Jun 23, 2006 16:01:43 GMT 12
Post by bevan1nz on Jun 23, 2006 16:01:43 GMT 12
Yo ET was it a switch problem??
|
|
ET
Junior Member
Posts: 65
|
ESC ??
Jun 23, 2006 19:30:45 GMT 12
Post by ET on Jun 23, 2006 19:30:45 GMT 12
Hi Bevan Ummm well to be honest i didn't even know what i did different from yesterday eh.....i hooked up the ESC except the motor wires, turn the switch on then the controller, and the ESC didn't flash it's red light so i pulled the trigger,held it for about 3seconds, then pushed the small set button on the ESC, then i pushed the trigger forward for 3 seconds and hit the set button, turn the switch off, hooked the motor up turn the switch back on and it went ......lol ya hoo..... So yea i must of Tu Tu to much last night he he ET...
|
|